Backdraft
A backdraft (North American English), backdraught (British English)[1] or smoke explosion is the abrupt burning of superheated gases in a fire caused when oxygen rapidly enters a hot, oxygen-depleted environment; for example, when a window or door to an enclosed space is opened or broken. Backdrafts are typically seen as a blast of smoke and/or flame out of an opening of a building. Backdrafts present a serious threat to firefighters. There is some debate concerning whether backdrafts should be considered a type of flashover.
Burning
[edit]When material is heated enough, it begins to break down into smaller compounds, including flammable or even explosive gas, typically hydrocarbons. This is called pyrolysis, and does not require oxygen. If oxygen is also provided, then the hydrocarbons can combust, starting a fire.
If material undergoing pyrolysis is later given sufficient oxygen, the hydrocarbons will ignite, and therefore, combustion takes place.
Cause
[edit]A backdraft can occur when a compartment fire has little or no ventilation. Due to this, little or no oxygen can flow into the compartment. Then, because fires reduce oxygen, the oxygen concentration decreases. When the oxygen concentration becomes too low to support combustion, some or all of the combustion switches to pyrolysis. However, the hydrocarbons and smoke (primarily particulate matter) remain at a temperature hot enough to auto-ignite. If oxygen is then re-introduced to the compartment, e.g. by opening a door or window to a closed room, while the gasses are still hot enough to auto-ignite, combustion will restart, often abruptly or even explosively, as the gasses are heated by the combustion and expand rapidly because of the rapidly increasing temperature, combined with the energy released from combustion.
The colour and movement of smoke is used by firefighters to infer fire conditions, including the risk of backdraft.[2] Characteristic warning signs of a backdraft include yellow or brown smoke, smoke which exits small holes in puffs (a sort of breathing effect) and is often found around the edges of doors and windows, and windows which appear brown or black when viewed from the exterior due to soot from incomplete combustion. This is an indication that the room lacks enough oxygen to permit oxidation of the soot particles. Firefighters often look to see if there is soot on the inside of windows and in any cracks in the window (caused e.g. by the heat). The windows may also have a slight vibration due to varying pressure within the compartment due to intermittent combustion.
If firefighters discover a room sucking air into itself, for example through a crack, they generally evacuate immediately, because this is a strong indication that a backdraft is imminent. Due to pressure differences, puffs of smoke are sometimes drawn back into the enclosed space from which they emanated, which is how the term backdraft originated.
Backdrafts are very dangerous,[3] often surprising even experienced firefighters. The most common tactic used by firefighters to defuse a potential backdraft is to ventilate a room from its highest point, allowing the heat and smoke to escape without igniting.
Common signs of imminent backdraft include a sudden inrush of air upon an opening into a compartment being created, lack of visible signs of flame (fire above its upper flammability limit), "pulsing" smoke plumes from openings and auto-ignition of hot gases at openings where they mix with oxygen in the surrounding air.
Backdrafts and flashovers
[edit]Although ISO 13943[4] defines flashover as "transition to a state of total surface involvement in a fire of combustible materials within an enclosure", a broad definition that embraces several different scenarios, including backdrafts, there is nevertheless considerable disagreement regarding whether or not backdrafts should be properly considered flashovers.[5][6] The most common use of the term[by whom?] flashover is to describe the near-simultaneous ignition of material caused by heat attaining the autoignition temperature of the combustible material and gases in an enclosure. Flashovers of this type are not backdrafts as they are caused by thermal change. Backdrafts are caused by the introduction of oxygen into an enclosed space with conditions already suitable for ignition, and are thus caused by chemical change.[citation needed]
In popular culture
[edit]Backdrafts were publicized by the 1991 movie Backdraft, in which a serial arsonist in Chicago uses them as a means of assassinating conspirators in a scam.
In the film adaptation of Stephen King's 1408, the protagonist Mike Enslin induces one as a last-ditch effort to kill the room.
The term is also used and is the title of a scene in the 2012 video game Root Double: Before Crime * After Days.
References
[edit]- ^ "Control measure - Understand signs and symptoms of backdraught". www.ukfrs.com. Fire Central Programme Office. 1 July 2021. Archived from the original on 9 July 2021. Retrieved 1 July 2021.
- ^ a b Brouwer, Ed (6 June 2008). "Trainer's Corner: The science of reading smoke". www.firefightingincanada.com. Firefighting in Canada. Archived from the original on 30 July 2019. Retrieved 30 July 2019.
- ^ Hall, Richard & Adams, Barbara (1998). Essentials of firefighting (4th ed.). International Fire Service Training Association. ISBN 0-87939-149-9.
- ^ "ISO FDIS 13943 Vocabulary". International Organization for Standardization. Archived from the original on 2012-11-08. Retrieved 2011-06-11.
- ^ "Rapid Fire Progress" (PDF). firetactics.com. Archived from the original (PDF) on 2011-07-23. Retrieved 2011-06-11.
- ^ Dunn, Vincent, Deputy Chief, F. D. N. Y. (Ret.). "Backdraft and flashover; what's the difference?" (PDF). vincentdunn.com. Retrieved 2011-06-11.